Buck Knife
110 Folding Hunter
This is the third version of the Buck 110 made in 1967 with a dot after Buck
The version identifier is the integrated brass spring holder, cast as part of the right frame butt and bolster and visible by a very thin off-centered line. The variation is identified by the inverted BUCK logo stamped on the left side blade tang and the bolster stud/rivet locations listed below each knife. The 'USA' was added to the logo stamp in late 1967
for export sales going to Canada.
The frames were cast in brass. The satin finished clip point blade is made of 440C
hand-rolled steel. The inlays are Macassar Ebony imported from Indonesia.
440C Blade Steel
Wood Handle with two small pins
Lockback
Closed Length 4 7/8"
Blade Length 3 3/4"
Comes with original sheath
Knife has been used and shows some sharpened